AD-4541 Signal Conditioner

The AD-4541 Analog Signal Conditioner device will accept an analog (mV) input from a sensing device such as a load cell, pressure sensor, strain gauge etc and convert it to an output control signal in the form of a voltage (-2v to +2v) or a current (4 to 20mA).


  • Choice of Signal Outputs- (-2V to +2V) , (4mA to 20mA)
  • Simple Calibration- Adjustment by potentiometer
  • Zero Adjustment Range- (-0.5mV/V to + 0.5mV/V)
  • Span Adjustment Range- (0.4mV/V to 3.2mV/V)
  • Simple Installation- Can be snap mounted onto DIN rail or screw mounted
  • Specific DIN Rail Configuration- Spring clips and a recess on the rear housing
  • Spring Clip Terminal Block- No screwing required for wire termination
  • Dimensions: 45mm x 122mm x 24mm per unit

Model & Capacity(scroll right for purchase/enquiry details)

Model Capacity Weighing Pan Unit Price
excluding GST
4mA to 20mA Output
NA $ POA Cart Enquire
-2V to +2V Output
NA $ POA Cart Enquire
  • Product Enquiry
  • Help & FAQ
  • Warranty
    • *** GOT A QUESTION?

      Please fill in the form below.

      For enquiries outside of Australia & New Zealand, please see the list of A&D Global contacts

      Please complete the fields below

      * Required field
    • Where can I purchase this equipment?

      A&D Australiasia has a nation wide dealer network with outlets in all capital cities and in most regional locations. Call Toll Free 1800 241 434 for the location of your nearest dealer.

      My product requires service/repair, how do I arrange this?

      Contact the A&D Australiasia Service department on 08 8301 8120 or at [email protected] and they can advise on and coordinate your service requirement.

    • All A&D products purchased within Australia are covered by a warranty period which varies from 12 months to 5 years depending on the model.

      Warranty covers against any defects in the material and workmanship negligence during the manufacture or assembly of the product for the period of the warranty.

      Warranty claims should be submitted through your initial dealer or place of purchase with your proof of purchase tax invoice.